From there it was on to the fairly limited electrical outlets and lighting and I ran a new breaker to the sub-panel we had installed in the basement last summer. I went cheap and easy single switched wall mounted sconce lamps, two of them, centered on the wall above what would be the bed's headboard location. The one outlet I had which was on a concrete wall, I face mounted and ran through PVC conduit with a PVC outlet box.
For the small section of exposed concrete block wall, I simply painted the wall with color tinted masonry paint and left it bare rather than framing, insulating and sheathing. If it is too cold, I can always do something in the future but I spent 3 years living in an uninsulated cinderblock dorm at UVM and it was just fine. Sure, I'm losing heat but insulating a basement in a climate with deep penetrating ground frost is a recipe for busted walls.
On the walls of the bedroom I used my old friend, 10" rougher back V groove tongue and groove pine planking. I sealed it with Thompson's water seal on both sides and then nailed it up horizontally. I source this wood from Maine, where the lumber yard has it custom milled for them. At $.73 a board foot it is hard to beat price wise and gives the feel and character I'm looking for, that of a rustic cabin.
On the outside of the main divider wall I used an inexpensive, exterior grade siding made of press board. It comes in 7/16" thick 4x8' sheets that have shiplap overlapping edges. It is molded to resemble textured V grove planks and comes pre-primed. It is stable, moisture resistant, tough and cheap. When you paint it, it even looks pretty good.
I also got the floor down in the bedroom. We went back and forth as to what to use on this, nothing, concrete dye, porcelain tile. We decided to go with 2x2' raised basement underlayment panels, which use corrugated plastic base under a 3/4" weatherguard OSB interlocking panel to add some moisture protection. On that I used inexpensive interlocking laminate flooring with a styrofoam pad underneath. I've had good luck with the overall stability of the laminate flooring in a mudroom area that saw a fair amount of moisture from tracked snow in the past. This basement is dry as was proven last summer and over this past winter, a season of many freeze thaw cycles and good amounts of rain. I'm also planning to run a dehumidifier as well and the basement is a walkout, so is only partially below grade.
The last bit of project that I got done this week was to put in the initial section of ceiling between the main carrier timber and the bedroom wall. This section only had a 9" gap so rather than raise the ceiling to the bottom of the floor joist, I went from the bottom of the carrier beam over to the bedroom wall.
For the ceiling I wanted something that was light, bright, clean and easy to remove in case I needed access to anything above; wiring or such. After some though, I decided to go with vinyl soffit, which I've worked with a number of times before. I love the stuff. You just need ledges from which to span it and for than, I used simple pine planking that I routered a 45 bevel into to dress it up a bit. On the base of the beam, which is an old hemlock 4x6" that I sistered with pine 2x8" on either side and then a 2x4" on the underside channel. I put a pine 1x8" on the bottom side that overhung to the side of the wall, which gave me my ledge from which to hang the soffit up over. The end result is clean, looks good, was easy to install and is functionally great.
I'm trying to get creative when choosing building materials and build this area with an eye toward function. I'm using things that can maybe handle a little humidity or possibly moisture while keeping cost reined in. We'll see how it all works out but so far, so good. I really enjoy re-purposing things for uses other than that which they were intended. Bottom line is that it's fun and I finally am getting back into the swing of accomplishing something tangible.
Lots more to do. The bathroom is going to be interesting for sure. I've got some neat plans for materials for that one. Can't wait to get started.